You have been weighed, you have been measured, and you have been found wanting. Come back when you're worthy.

Managed to get quite a bit accomplished. Sat down with a few bad movies and started wiring.


Player 1 buttons. The wiring won't be tidied up until the artwork is applied, as I need to take the entire thing apart to apply the artwork.

This is the Happ trackball X axis connector. They have a AMOA plug in place with a harness. You unplug the X axis connector and Y axis connector and the Mini-Pac plugs directly in.

These are the Mini-Pac trackball connectors. Y-axis on the left and X-axis on the right.

Spinners installed. Had to countersink the bolts for them to fit flush. I probably could have used a #6 screw, but I went with a #4 as the mounting holes seemed quite small.

Player 2 buttons.

A start and coin button. The coin button is black.

The control panel is a monster and I wasn't able to reach from the bottom of the panel to the top to attach the coin buttons. I purchased some male quick disconnects and used those to plug into the Mini-Pac wiring.

Here is a nice shot of the Mini-Pac wiring.